Búsqueda por vehículo

K&N Nine Inch Air Filters

K&N Nine Inch Air Filters

K&N Nine Inch Chrome Air Filters

Ideal when space is a problem. K&N Filtercharger® element provides superior airflow. Five flange sizes and various heights assure a wide number of applications. Polished stainless steel construction for top and base plates. Can be mounted on most dual carb setups.

Neck
Flange
Element
Height
K&N P/N
Element
Foot
Note
K&N P/N
Complete Assembly
Total**
Height
2-5/8" 2" E-3527 4 60-1070 3.37"
2-5/8" 2-7/8" E-3530 4 60-1080 4.12"
3-1/16" 2-7/8" E-3530 4 60-1090 4.12"
4-7/32" 2-7/8" E-3530 4 60-1100 4.12"
5-1/8" 2" E-3527 4 60-1110 3.37"
5-1/8" 2-7/8" E-3530 4 60-1120 4.12"
5-1/8" 5" E-3650 4 60-1365 6.37"
7-5/16" 2-7/8" E-3530 - 60-1370 4.12"
7-5/16" 5" E-3650 - 60-1366 6.37"

Nine Inch Tall Velocity Stack Air Filters - Stainless Steel

Nine Inch Tall Velocity Stack Air Filters

Open 360° free breathing 9" Filtercharger® element on top of a 5" high stainless steel velocity stack base. Draws cooler air up and away from engine heat. Engines equipped with the K&N Tall Velocity Stack Air Filter can actually produce MORE horsepower than those with no filtration at all. All stainless steel top and base, highly polished to a mirror finish. Available with 5-1/8" flange to fit Holley, Carter or Rochester carburetors. Choice of two element heights assures proper airflow for virtually any engine. Also available with 7-5/16" flange to fit Holley Dominator carburetors. Note: These K&N assemblies are not U.S. Coast Guard approved for use as a flame arrestor.

Neck
Flange
Element
Height
K&N P/N
Element
Foot
Note
K&N P/N
Complete Assembly
Total**
Height
5-1/8" 2-7/8" E-3530 - 58-1190 8.25"
5-1/8" 5" E-3650 - 58-1191 10.50"
7-5/16" 2-7/8" E-3530 - 58-1200 8.25"
7-5/16" 5" E-3650 - 58-1210 10.50"

Note: Legal in California only for racing vehicles which may never be used, registered, or licensed for use upon a highway. See knfilters.com for CARB status on each part for a specific vehicle.

FOOTNOTES 1) Includes vent kit 2) Vent kit available, P/N 85-1190 3) 1/2" vent tube on base 4) 3/4" vent tube on base 5) Top is chrome & base is hi-temp nylon 6) Stainless Steel top & chrome base. * Will not fit Edelbrock carbs with electric choke. ** Total Height = minimum clearance required above carburetor flange.